Crimp sleeve size for Moor Subtroll

[Sea Lion]

Hi Gang,

      Sorely need to reattach my subtroll and was wonderng if someone would know the particulars of the crimp sleeves for the 150 lb test wire.  Just trying to buy at my local hardware store if possible.

 

Thanks,

 

Bob

[Richard]

I do not use crimps. the chance of over crimping and damaging the wire is too high. I use the clincher to terminate my end.

 

http://www.fish307.com/howtorigaspeedandtempprobeclincher.aspx

 

Moor sells the set up with the hole already drilled out and the screw is included. their part number is 88-088-032 

 

Hope this helps.

 

Good luck and tight lines.

[Sea Lion]

Hi Richard,

Thanks for the information. Sorry I didn't thank you sooner. Normally I get an email when I get a response but didn't this time.

Regards,

Bob