Want to buy a bigger boat and this one needs a new home, make me a reasonable offer and take it home, 10K OBO

1984 Penn Yan 26 Open Fisherman with 10 foot beam, conventional IB,
not a tunnel drive, . The boat recieved new stringers and a new transom core, The exterior was professionally refinished with single stage polyurethane paint above the waterline. including the interior, excepting the non-skid liner. All thru hulls above and below the waterline were replaced with bronze units, The boat has three 2500 GPH bilge pumps and a freshwater washdown pump,
2 new 27 series marine batteries and selector switch and 2/0 battery cables.
. There is an extra 17 x 15 Nibral prop included, I bought this for a spare. The work that still needs to be completed is a headliner and hull covering for the cuddy, also the head needs a new holding tank and hoses installed, Ill do this work for a buyer if they buy the materials, no labor,The motor has about 900 hours on the meter, and the trans has less than 200 since new, This is a sweet running boat that cruises at 28 MPH @ 3100 rpm and tops out at 38 MPH at a bit over 4100 rpm
The boat has a totally level floor from the helm to the stern, no dumbass motor box to get in the way, almost 100 sqaure feet of open floor.Electronics include a, Sitex CVS 106 with bronze thru hull transducer, A Garmin GPS map 162, and a new Uniden DSC capable VHF. Also, the boat has a Simpson Lawrence
windlass, and a new 150 foot rode with Acco chain, which makes anchoring and pulling a flip of a toggle switch.

Want to add boat is docked in Ashtabula, Ohio, approx 2.5 hours down 90 from Buffalo

Guys this boat looks just as good in person as it does in the pic's. I'm docked in the river as well, I've seen it a few times this past summer.

Please drop me an E Mail, couldn't find the member list to pm,
atommik@twcny.rr.com

TYVM

Tom

Somebody needs to buy this, I need the money for the down payment on my new boat, shoot me an offer, just might accept it

new price, boat is out of water, it needs to go

Very nicely done. What would the cost of materials be to finish off the boat? The canvas looks new. Does it have a drop back enclosure too? I hear those single inboards are a bear to handle in close quarters? True?

I took this boat for a test ride late last season and it was nicely done up, no back drop at the time and the owner quoted a few hundred bucks to finish it off not counting back drop, prolly 4 to 500 for that.

She was clean, owner was a stickler on the price, wouldn't budge, and yes for a first time owner with a true inboard single screw it takes some getting use to, but not as bad as most people make it out to be, once you get some time under your belt its not that bad at all. Even more time under your belt and it gets easier.

Sharp boat for sure,
Tom

added a new backdrop and rocket launcher before this springs launch, if it sells for 10 k Ill finish the cabin as part of the deal heres some more pics





http://www.flickr.com/photos/30613332@N ... 2866767764

Great looking boat! Wish I had the $$, this would be a great second boat for me!

is the trailer included???

Trailer goes with boat, its a bit undersized at 6K, I just use it in the spring and fall about 35 miles each way, tires and bearings are new , new wheel cylinders and surge coupler 2 years ago

Do you have any pictures of the cuddy??

I have seen this boat up close and it is AWESOME! If you didnt know before you looked at it you might think it is a 2009. You wont be dissapointed in a Penn Yan.

GreyBeard, let me know when Team Effort is done:)

And what would that New Price be? Last I read was 10K and you would complete the cuddy and replace the holding tank and hoses for the buyer. Has it been Winterized for the season. It could go real quick. Let me know.