thork9

Where's the lakers I'll fish for them, I'm have trouble finding them I give up for now on the salmon I'll fish them when they are really there, how deep.

We're the laker grounds in the Bay Area , I have to find them and catch some, while I'm waiting for the salmon.

True

Anybody see them in shallow? 60 and under?

Fleas are terrible, I did 3 small salmon off the dunes 150ft water, great calm water.

Mexico point

Thank you

Yesterday, 4 lakers, marked some bait down to 80 saw some marks same depth. Fished for lakers only.caught all on bottom 105 ft in front of plant. Morning fished sandy pond area found no marks or bait.

Was there Wednesday caught two small Browns by the plant marked a lot of fish but wouldn't go. 70 feet to 40 was were I was marking , tried deeper blank screen. Fished five hrs. Caught the two rigger 30 ft down.

Show us picture with line on it, set up. Mine doesn't do this.

Should install no feed back steering, then you could get rid of bunge! Great job

Fished late 9-1pm top 30 ft by plant caught 2 10lb Kings on dipsey set a 100 ,NBK stinger water was 56 on surface. Lots of bait marked.

What winds do you need for warmer waters? I'm new as in fishing early, i usely come mid summer on.

Can you tie to wire mono, to run dipsey slide diver with a twirly tip? Will the mono handle the tip as far as breaking/wear? Thanks for response.

How about towards east shore, north of the river? Sandy pond area. I'm going midweek might try out that way. I have problems finding the right area, depth , not seeing bait, etc this is first time I docked the boat for the yer, I usally fish July, August , any suggestions? No problem later in year.

I peel the skin off ,cut the dark lateral line out, deep fry or broil tastes great like haddock. Leave skin on or line tastes like crap.

It costs to much for gas to run my boat that far, I'll have to settle for lakers just can't find them to good was out by the plant 80-100 ft caught one

Are the lakers better towards the plant or towards sandy pond? 100ft ?

Has anyone have any info on the black box, does electricity work in ontario for salmon? I have used it for lakers in lake George ny . It did work but I have a new boat and wondered if I should use it. Oh it's made by Scotty.

Outstanding! But we're you from, a secret location?

We're are you?

I had similar problem was connector between main cable and short cable at down rigger.

Should have been here last year, unbelievable with fish.

I was stopped at the little salmon river by dec biologists. They were checking fish I had some and as they were measuring I asked where's all the fish? They state that last fall the two year olds ran with the three year olds and that is why we are not seeing the numbers. They state they don't no why or how many ran last year. They said they will now after the run this fall. But will not really no why. Mexico area was ok but not the numbers I saw last year in the boat or on the sonar.

Take a electric meter touch down rigger cable with red probe and ground the black probe to motor or a metal surface and read voltage milo lot setting doc and see if they are the same check both cables. If boat isn't grounded properly (down rigger ) you might have a higher voltage. I had this problem with a down rigger , you should read lower than .500mv. I had one almost six volts blew the fish away no hits. If you have higher mv reading use a longer lead 50 ft. Look up black box for fishing will explain better than me.