JTM203SOUTH

I AM LOOKING FOR VERTICAL BLADES WITH SMALL TO MEDIUM SIZE BLADES ( 2 I/2 T0 3 INCH) . ANYONE KNOW WHERE I CAN BUY SOME ? THANKS, JACK

PM sent

lrg355 , Thanks for your input. Jack

Hi, I have been looking at some 25 HP outboards and am interested in Yamaha due to its new feature of Variable trolling speed (VTS) which allows adjustment of as little as 10 rpm at a time. Has anyone used the Yamaha with this feature and,if so, how well did it work ? Thanks, Jack

I roll them a little loose and the store each of them in the leg portions of old blue jeans that have been cut off. Has worked great for years. Do not store wet !

Looks like two separate issues. Depending on the scale you are using on the MFD , the digital depth reading could easily vary from the depth scale on the side of the graph. Try changing you max depth on the MFD to something closer to the depth of the ball. The variance on the rigger readout could simply be a wrong reading on the rigger's counter. As an example, when the springs which drive the counter on my BIG JON riggers get worn and weak they slip, especially if you run the rigger down fast. Try marking the cable at various measured points and see if they match up with the rigger's counter. The same sort of thing often happens with counter fishing reels if you reel them in too fast.

Verify that the head unit has power and is working. When hooked into your 12 volt supply, you should see a small black dot or decimal point in the lower digital screen which would show the temp if a working probe were attached. No "dot" means no power or a bad head unit. If the head is working , follow the advice above to check out the probe..