Cannon Mag 10A Spool Removal

[Consigliere]

Any tips on how to take the spool of a Mag 10 A?  Easy to get it down to just the spool and shaft in place with both nyliner bearings, but not sure how to get the shaft out.  Think I have a rigger with two bearings shot that may need replacement but can't figure out how to get it all apart.

 

http://www.fish307.com/images/schematics/Cannon/Cannon-Mag-10a-schematic_lg.jpg

 

It is parts # 14 and 17 on this schematic.

Edited July 23, 2013 by Consigliere

[rlconverse]

Once you take the electric motor cover off the side n remove the cable. On ur schmetic drive out number 13 easly. That will free up the shaft n spool. Its in the center of the spool

[Consigliere]

Could not see a way to get at #13 set screw...but will look again.

[rlconverse]

Should be a basic roll pin in the center of the spool. Just got to pull all the cable off

[Consigliere]

Taking the cable off is what I was missing....duh....thanks!

[rlconverse]

No problem. Good luck to yah