fish hawk x4d

[xjbob99]

i just got a new boat and put my fishhawk on it, i never had a problem with it on my old boat. i took it out the other day and tried it for the first time on the new boat. i turned the display on and it reads the surface temp for 30 seconds then it makes me calibrate it, so i just press the set button through all the calibrations. Then it wll read surface temp again for 30 seconds and shut off. the display shows a backwards c in the lower right hand corner. i tried putting the probe in the water but the batteries were dead.... so my question is, will the display act like this when there is no probe. when  i used it before the display would stay on and it would just read surface temp.

 

 

 

[Broadhorizons]

On my x4 it will still give surface temp without using the probe. I would suggest calling fish hawk directly. They are very helpful.

Good luck, Andy

[vetting]

It should still read surface temp without the probe in the water.  Are you sure the ducer cable is screwed in all the way?  Also check the full run of the cord for damage.  

 

If you email fishhawk with issues, they usually respond within a day.