Klincher for Sub Troll

[JakeyBaby]

Anyone happen to know of a place that carries these in the Rochester area? I'm looking for one asap. This is the connection where your sub troll cable meets the ball.

Thanks

[ERABBIT]

You can make your own...........

 

http://www.fish307.com/howtorigaspeedandtempprobeclincher.aspx

[joe g]

depending on which release you use you wont need one... if using a walker or blacks you can tie directly to the loop of the release.. make sure the stripped cable is in contact with the loop of release. use the 'wire' knot that is talked about for terminating stainless steel diver lines.  wrap any exposed cable with the rubber conductive tape and good to go

[Gill-T]

depending on which release you use you wont need one... if using a walker or blacks you can tie directly to the loop of the release.. make sure the stripped cable is in contact with the loop of release. use the 'wire' knot that is talked about for terminating stainless steel diver lines.  wrap any exposed cable with the rubber conductive tape and good to go

 

What he said.  Save your money and use the wire line knot.  Place a crimp, a bead and a blacks release on cable 1st.  With coating stripped off, tie a wire line knot and cinch down with pliers tight.  Bring crimp/bead/release down wire to just above the knot.  Easy.

[Legacy]

Order it directly from moor...

Sent from my E6782 using Lake Ontario United mobile app

[JakeyBaby]

Problem solved!! Thanks guys