LOwrance Elite 5 DSI

[potsie225]

For some reason my unit does not show the depths of the water I am on or names of points or islands. It used to do all of these, do I need a upgrade. TY Doug

[Sk8man]

When you say "the names of points" etc. I'm assuming you are referring to your mapping program (e.g. Navionics, Lowrance or other etc.) If so check to see in the nested menus if the correct mapping program is indicated and if not select the right one (e.g. Navionics vs. Lowrance) If you are talking about GPS waypoints check the settings for the GPS menus in that screen and see whether you have the overlay data turned off. When all else fails go back in and reset it to factory defaults but you may have to re-install any software updates again afterward. This is based on the assumption that your transducer hasn't gone bad.

Edited October 19, 2015 by Sk8man

[shinintimes]

I would say you nailed it Sk8man with the factory defaults he may have unknowingly turned something off

[potsie225]

Thanks for the info, I did reset default and its now looking like it use too.

TY Doug