Jump to content

Fish hawk x4


Recommended Posts

Ok so my fish hawk is not reading down temp or speed and I believe the probe works as the red light blinks when I drop it in water. So I'm thinking it's the transducer? I'm wondering in its even worth trying to open up the end connector and trying to make sure the connections are solid or just buy a new triducer. Thanks for lookin!

Link to comment
Share on other sites

LC;

I would leave the transom ducer alone, try your probe on someone else's boat to rule out the probe. Once you break the seal on the ducer, it will be open to water infiltration.

Good luck

John

Link to comment
Share on other sites

I had a similar problem. It turned out to be the connections on the back of the display unit. I pulled them out cleaned them off put them back in and bingo everything works again.

Link to comment
Share on other sites

I had same as rolmops....... I have two boats set up with fishhawk. I took the probe that was acting up and used it on the other boat. Worked perfect. Back and forth I tried between boats and probes. Ended up the wires it the back of the display were loose.

Sent from my XT1254 using Lake Ontario United mobile app

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...