Jump to content

Aluminum floor thickness


Recommended Posts

Man, for the life of me I couldn’t remember what gauge I had a fan shop redo my floors in. I do see you may need to add some supports across your stringers. I had the going across about every 2ft or so then the foam between them that I poured then the floor. Gas tank was in the middle with its own cover. You may check that to see if it’s that thickness you need of it’s not wood.


Sent from my iPhone using Lake Ontario United mobile app

Link to post
Share on other sites

I have an aluminum floor, if I remove a (screwed in place) access cover I can measure it, I’m pretty sure it is no more than 1/8”, and my stringers or supports are approx 12” on center with closed cell foam filling the cavity’s between them so 1/8” would be more than adequate. I re-drilled and used large head aluminum rivets to put floor back down


Sent from my iPad using Lake Ontario United mobile app

Link to post
Share on other sites

1/8” aluminum diamond plate. Looks great and works perfect with this boat. I did one a few years back. I wish I would have taken pictures.


Sent from my iPhone using Lake Ontario United

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...