Jump to content

Recommended Posts

Hey guys finally took my boat  out for a shakedown. Canon mag 10 the auto up will start to go up like 20’ft and then stops. Any ideas?

Pull cable out the crimp or set screw that connects cable depending on model is dirty or corroded


Sent from my iPhone using Lake Ontario United
Link to post
Share on other sites

If what suggested above doesn't work, and you have two of the same riggers, swap the spools and see what happens.  If the same issue occurs on the other rigger, wire issue.  Much cheaper and easier fix than a board.

Link to post
Share on other sites

You may also want to check the power cable itself if you have the older type cable as they were notorious for the outer covering cracking and then shorting out. If you have the new er cable disregard.

Edited by Sk8man
Link to post
Share on other sites

Sk8man these riggers are mag 10. They are older. I bought them off a buddy. He replace wires and plugs about 5 yrs ago. He used different plugs and wire. They have been fine until now. Last year I replace board on other rigger because terminal broke off . After this year it will be time to start farming them out. Could be condensation because he used some funky sealer to seal them

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...