Jump to content

Fishhawk not displaying transducer info


Netbender

Recommended Posts

Good Day, 

You don't know how much you need it until its gone.........

My x400 has stopped displaying down info. The surface temp and speed display fine. The down temp and speed or just dashes with the decimal point showing on both. I have tested the batteries and all are good. I have pulled the nose cover and touched across the two temp sensors....no flashing led at all. No led when in the water either. Was working fine last trip out. 

 

Anyone have any thoughts? 

 

Thanks, Dave

Link to comment
Share on other sites

  • 3 weeks later...

just got my new battery pack and wiring replacement. The wiring harness was the issue. I guess the constant pulling off of the 3 prong connector each trip is not a very good idea. I think I will just unscrew the plastic head and allow air in and not take the wires off for now on.

 

Dave

Link to comment
Share on other sites

I'm not sure if the directions say to unscrew the cap each time but I would and am scared that you may wear out the o ring. All I do is take the bumper off every time. Good luck,    Matt

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...