Otter boat rope

[tyler.woodard04]

Bought some used boats and I need to make new pull point harnesses. Any recommendations for what to use?

[spoonfed-1]

I bought a roll of I believe it was parachute cord that works good. I'll double check what it was when I get up to the lake tomorrow. I fact I got a lot left so if you happen to be going through mexico I can give you some.

[tyler.woodard04]

thank you.  Ill let you know

[GAMBLER]

I use parachute cord.  

[tyler.woodard04]

thank you.  anyone backing up the knot at the board with a washer to help distribute the weight?  may not be needed just curious.  also what is the target length of each leg of the rope?  thinking the loop needs to be forward of center?

[nhjim]

we run a fender washer between board and knot. legacy did a post few years back think was front board to knot 9" knot to back 11" seem to pull good.

[tyler.woodard04]

That's is the same I ended up with, including washer. Thanks for the guidance everyone