tpsball
-
Posts
38 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Store
Posts posted by tpsball
-
-
Browns in close 35-40 FOW, marked a lot of bait, few fish.
Waiting for Kings!
Sent from my SAMSUNG-SGH-I337 using Lake Ontario United mobile app
-
Roger that
Sent from my SAMSUNG-SGH-I337 using Lake Ontario United mobile app
-
Do they take them out every year? This is the first time I haven't seen them. This is an observation from land, boat hasn't made it there yet.
-
We'll, I do know that the Plant is starting to relax some of the knee jerk reactions after 911, and was wondering if the buoys were one of them? Have not seen the coast guard out here at all
-
Anybody know anything about the buoys being pulled, or did they sink? I have seen a few boats within the zone. Just wondering.
-
SOLD
-
Runs like a top! Call 315-593-5050
-
1988 BAyliner Trophy 2160 21' Hardtop, 4cyl 3.0L, OMC Outdrive, swim platform, Rocket Launcher rod holders, marine radio, am fm radio, fish well, live well, Dual Axle Trailer, VGC $3500 call 315-593-5050
-
Looking to get some trolling rods, 8'6" or 8' buy would like m/lt action. I have 8'6" Okuma M action for kings, but too stiff for Browns. What do you guys think? And where can I get them? Thanks.
Sent from my SAMSUNG-SGH-I337 using Lake Ontario United mobile app
-
Hello, Looking to upgrade to either 24' or 26' Hardtop, Thompson, Penn Yan, etc., I know it's early but let me know what you have. Thanks
-
probe needed ASAP, does anybody have one or know of any place to get one, very hard fishing without one! Thanks, Big D
-
Effed up starter bolt hole 4 cyl inboard
in This Old Boat
Posted
Went to replace the starter on my omc 3,0 L and the inside starter hole had been previously drilled out and badly done! There was never a bolt in this hole for the 3 years I've had the boat, it was shimmed up on the outside with a washer. How it worked this long is beyond me. They drilled the hole out and inserted a helicoil. I removed the helicoil and tried tapping the hole out correctly but no go! I would guess the angle is approx 20 degrees. Other than pulling the motor out I'm not sure what to do next. And, if I pull this motor out I want to get rid of this under powered 4 cyl and go to a 4.3. Does anybody have any ideas on fixing the bolt hole problem or going bigger? It's a 1988 bayliner trophy 2160 hardtop, I'm pretty sure the 4.3 and 5.0 were options. Thanks in advance.