L&M

Readjust your idle mixture, what your describing is normally a lean mixture at idle. 

39 minutes ago, sodus_guy_09 said:

As of 3 days ago the road down the bluff leading to it was real tough I guess

That it is but the channel is open. It's a little extra run time for sure but the south launch is open & in good shape

Channel is open & navigable

If it's the drive that should go with that engine it is a 1:81 ratio

Here is a pretty good chart that breaks different scenarios down.

https://www.boatzincs.com/pdfs/Chart_B-Which_Anodes_Should_I_Use.pdf

It's normally open on or by the 1st of April, but with what has been going on this last couple of months they have just started on it. I would think it will be open next week some time. 

3 minutes ago, Hawkeye50 said:

I use small bead chain in Spring, helps keep debris off Lure,later in season will change to heavier bead chain to connect leader to main line on spoon rods.

X2

12 minutes ago, UNREEL said:

X2

https://tgftp.nws.noaa.gov/data//raw/fz/fzus61.kbuf.glf.lo.txt   

Boat is sold 

Got it Dick  thx 

1989 Sylvan Rod Master Center Console

1996 115 hp Johnson outboard with VRO

9.9 hp 4 stroke Yamaha kicker with throttle control

Auto Pilot

2 Scotty elect riggers

Lowrance sonar

VHF radio

Moor Sub troll

Complete enclosure canvas

Load Rite galvanized trailer with power winch

Dedicated battery for winch

Complete package is in excellent cond.

$8600.00

Listing for a friend, Please pm me for any additional questions & contact info

A Happy & Safe Easter to all 

Probably be 60 come tomorrow   

I'm assuming it's twins, switch senders from one to the other and see if the starboard engine does the same with the port sender in it . Not often they go bad but it could save a lot of needless time & $ in the end.  

53 minutes ago, MikeyP said:

What size engine do these fit?

Most  Mercruiser / Mercury

Nifty idea but I think your going to need some deflectors on the sides to contain the water & if your running the engine for any length of time as per breaking in the cam/engine keep a close eye on the temperature as your just recirculating the cooling water   

1 hour ago, Reel Doc said:

Hoping to get out this weekend too.  Low water at Dean's so hopefully Taughannock will work with the trim up... 

Me too, I'm waiting to see how the new toys work out for ya 

Thats what it is & it's not as easy or for that matter possible to convert over to hydraulic as a Mercruiser would be that was explained in your other thread. 

https://www.lakeontariounited.com/fishing-hunting/topic/83842-what-auto-pilot-are-you-using/

6 hours ago, Sk8man said:

Haven't watched racing since Danica left

I take you didn't care much about racing then

Rick Meade in Clyde NY  pm me if you need more info 

http://meadeautomotivemachine.com/

Looks like it could be a Gizzard Shad from that angle

Are you sure that OMC isn't power assist cable steer. Unless it's been converted that

is what it should of came with.