Jump to content

larryb

Members
  • Posts

    5
  • Joined

  • Last visited

Everything posted by larryb

  1. For Sale 1991 Sportcraft Fishmaster 232. The boat will fish 4 people comfortably with seating room for four under the Hard Top. The boat is equipped as follows,It is an I/O - the main engine is a VOLVO 431 (V6) closed loop antifreeze - dual water cooling system. The out drive is a Volvo dual prop. It is set up with a 2003 15 Hp 4 stroke auxillary enging mounted on a heavy duty lift bracket and a quick link steering connector. The boat is equipped with a sink, a filleting station, and a raw water washdown system. It has roof mounted (rocket launcher) rod holders and rod holders mounted at the engine cover.It is set up with Dual Marine batteries and a battery selector/cut off switch. It has a marine radio, an AM/FM/CD player/stereo, a ray marine auto pilot new in 2011, two big john captains pack electric down riggers with 4' booms. It comes with a 2002 Venture galvanized trailer. This is a dual axle trailer with surge brakes on both axles. Tires are good and lights working properly - it is road ready! I bought the boat in 2007 and fished Lake Ontrario with it untill July of 2012. I am selling because I bought another boat. The asking price is $11,950.00 and comes as described above. The photo's show some gear and a radar unit that I have removed for use on my other boat. The Boat is stored in Granville Summit, Pa. and can be seen by appointment. Thanks for looking.
  2. what is the model number of the autopilot? How much draft is required for the boat?
  3. I have a 15hp evinrude long shaft electric start with remote control & cables. It is in very good condition,should work for what you want to do.
  4. Tom; I had the same problem you described, it went on for quite a while. I contacted Moore, sent the probe back etc.,ect.,etc. What I finally found was that the coaxial cable that runs from the antena to the dial had bad connections. The center conductor was never soldered even though it looked like it was (cold solder joint) both ends of the cable had the same problem. To solve the problem you can pick up a new coax cable at an electronics store. You may have a problem finding one long enough, but you can put a couple of them together, (will need to buy a small connector to join them). I think the longest ones I could find were 15 foot. This solved my problem, the unit has been working great for the last two years..
×
×
  • Create New...