Jump to content

Jack

Professional
  • Posts

    505
  • Joined

  • Last visited

Posts posted by Jack

  1. I have a 62 gallon plastic tank that I keep close to empty with stabilizer and then fill it up with Hi-test in the spring . Never had a problem yet . I also use additives all summer (cleaner and stabilizer). When I change my water separator filter in the fall I never see much if any water in it .

    Good Luck!!

  2. Thanks for all the good info !!!

    I may pick up some 4 ozer's for my 300 copper . I fell like I'm a year older by the time I get the 300 back on the reel so adding a 4 oz weight instead of using a 600 copper sounds Great .

  3. Hi !

    I bought some Michigan Stinger 1oz Dive Bombs to add to some flat lines to get them down a bit. If I were to run 200' of line out where would I want to add the dive bomb . (middle , close to lure,????)

    Thanks JT

  4. If your trolling 12 hours a pop I would add a kicker . If you buy a kicker build for trolling ( high thrust / big foot ) they will troll all day on a fraction of the fuel and won't coke up. Why put that kind of hours on a bigger motor that would cost $10-20 k to replace .

    just my $.02 ... Good Luck !

  5. I just installed my DR and used the same knot I use on my wire divers . I went about 3" up the end of the cable and striped about an inch of coating off so the bare spot would make contact with the swivel . I also added a rubber stopper from my Cannon terminator kit I had so my cable retriever wouldn't slip over the swivel . Fish last weekend had 150' of cable out and still had a great signal . DR gives you some special tape I used to cover the bare ends. Used the same knot to make my short cable from the prob to the weight.

    Good Luck ! JT

    Picture_049.jpg

  6. Hi !

    I would push on the outdrive by standing on it and see if there is any flex on the transom . If there is any flex I would get it fixed , if not you may be OK for awhile .

    Good Luck !

    JT

  7. Hi !

    Friday I went out for the first time this year and tried out my new toy (Depth Raider speed and temp at the ball ).

    Just to get the hang of things I ran the probe down a foot or two from the surface. I noticed that the temp and speed were different from what my FF and GPS were reading. If I was trolling at 3mp on my GPS the DR was reading 2.5mp and if the FF surface temp was read 50 degrees the DR was reading 45 degrees . Didn't matter which direction we went , with or against the wind.

    Was just wondering how normal these readings are compared to everyone else's ?

    We did catch 6 Browns , 1 Laker and a small King out of Sandy . Was a GREAT 1st trip !

    Thanks for any info on the Raider !!

    JT

  8. No matter what you buy I would lean toward the High thrust , Pro Kicker , Big Foot models . The engines run at a higher RPM when you are trolling so you will have better oil pressure and the alternator will be putting out a bit more juice. If you can I would also get electric start ,remote controls and tilt . I fish Lake O solo a lot and it is nice not to hang off the back of the boat in bad weather to work the motor . You can do everything right from the helm .

    My boat is the best part of 3K lbs and the Yamaha 8T has all the power I need .

    Good Luck !

    JT

×
×
  • Create New...