Netbender

Congrats!!!

Les, still using the old 20lb flea flicker from Cortland on my DR's. Been on there for 15 years, just before they stopped making it. Every time I go to change it out, I just can't bring myself to taking it off. Still works!!

Handsome!! Nicely done!!

I will be putting more time in with loaded gear shortly

Performance tabs seem to do the trick. Only have a few hours on them but there is a noticeable improvement

Just curious, how many entries this year?

Update: Smokercraft has recommended trim tabs. Electric units will not fit with the swim ladder and current kicker location. Second choice are performance tabs. They are currently being installed by the dealership. Do I have a hook in the hull? How does that occur with a new boat? Trailering? Does StarCraft repair hooks in the factory? Any thoughts welcome, Dave

I haven’t been at the boat since this picture. Are you going to take the covers off and take a look?

Good Day, I was just checking the engine mounts on my 9.9. Is the water discharge from around mid engine normal? Please check the water drops in the center of the picture. The stream continues through out rpm’s. Thanks Dave

IMG_2480.mov

IMG_2480.mov Additional pics of issue. Does the motor seem too high? I can’t seem to load my video on here that really reflects the issue

For those interested, finalized.

Good morning, thanks again for taking the time to educate me on this and providing guidance. A lot going on here. Everyone has been helpful. Heading out today for some fish! Dave

Sent videos to dealership. Changed the position of the trim tab anode to all possible positions. There was little to no improvement in the lean issue. Ran the boat in several different directions and varied rpm. Turning to the left seems to have more resistance than turning to the right when on plane. Pulled of the steering rod to the 9.9 and made sure the 9.9 was trimmed up full. Still has severe lean to port side above 2500 rpm to plane. Bow raises rather quickly when given throttle. Here is the anode position from the dealership. Thanks, Dave

Thanks guys for the information, this is helpful. I will be at the boat tomorrow afternoon and will be giving this a thorough looking over. I may send out a few more additional questions at that point. Thanks again for your support and guidance. Dave

All good ideas. Thanks Rodbuster for the pics, yes they look like different manufacturers. mr580, you are correct, I am not happy about any of it. I will spend more time with it starting Thursday. What can be done about the scratches at this point? Dealer is saying the kicker was trimmed up to much. Yea, well. I will tighten all the linkage and see if I can put the ball stud on top. Really not something I should have to do n a new rig.

RodBuster- Thanks! Pics would be helpful. This issue has been bothering me. Greatly appreciate your time and guidance. Dave

Thanks again for the advise. I will check all the recommendations Thursday when I get to the boat. I did hear back from the dealership. They are asking for a video of the issue to send directly to Starcraft. I am not sure if this is a good thing or if it will cause further delay. Assuming it will help. Dave

This bracket will raise an inch and then drop back down when lifted by hand. OK? Dave