uglyokuma

Members
  • Content count

    139
  • Joined

  • Last visited

1 Follower

About uglyokuma

Profile Information

  • Location
    Brooktondale
  • Interests
    Fishing and woodworking
  1. They have a gold backs Sent from my iPhone using Lake Ontario United
  2. I am trying to learn how to paint my own lures and I am looking to buy old Stinger Scorpion spoons or old Jr. Thundersticks. Don't really care how they look I plan on striping them and re painting. Here what I have done so far. Sent from my iPhone using Lake Ontario United
  3. We have always had them and they come in cycles. Usually we have them bad for a year or two then we have 3 years of less. All depends on when they apply the lampreyacide and how high or low the water level is when the do it. That's my 2 cents at least. I know one year the water level was so high that the fish ladder wasn't a barrier at all. Many of them just blew on by and did there thing. Sent from my iPhone using Lake Ontario United
  4. Fall Creek was loaded this spring too. Sent from my iPhone using Lake Ontario United
  5. I am on Keuka outlet a lot for work and it gets loaded every year with lampreys. Some days u can't cross the creek w/o seeing 2 or 3. Sent from my iPhone using Lake Ontario United
  6. I am on Keuka outlet a lot for work and it gets loaded every year with lampreys. Some days u can't cross the creek w/o seeing 2 or 3. Sent from my iPhone using Lake Ontario United
  7. Congrats Kade! Nice work Sent from my iPhone using Lake Ontario United
  8. Papa Smurf Sent from my iPhone using Lake Ontario United
  9. Will 10 colors fit on a penn 320 GTI? I have a few just collecting dust so I thought I would put them to work.
  10. Is 27 lb test necessary for fish the finger lakes??
  11. Looking to set up a couple rods with leadcore for trolling on the finger lakes. What brand do folks prefer? What lb test should I get?
  12. Just the prop on the shaft and I still have the same play when I really bear down on the nut?.
  13. I currently run a 115 hp Mercury Optimax on my boat and I noticed Thursday while checking thing out that the prop has about 1/8 to 1/4 inch of play in and out. I pulled the prop off and checked everything out and reassemble it and it still slide in and out the same amount. Is this normal?? If not how do I fix it?? Thanks for any input
  14. Launched at Treman today it was fine just keep the motor up until u get over deeper water. Lots of mud/ silt on submerged portions of the ramps.
  15. Anyone ever use an air brush to repaint their spoons? How bad is the learning curve? Are they expensive?