DoubleG

I just did mine last week. Here is how to measure them so you can buy the right one.

No I'm not sure but I think the cable that I'm replacing is about 15yrs old. I've only had the boat 6 yrs but I think they put the cable in when they put the motor on.

A friend of mine fished inside the wall all last week and did OK.

Here's a couple of pictures to show you what I mean. Sorry for the bad pics, it's all I have on my phone.

It's just a regular Teleflex cable but there isn't enough room between the motor and the wall where the cable comes out and there's also a slight angle. They had to have put the old one in while they were installing the motor. I can't see any other way to do it.

Awesome guys, thanks!!! I was thinking about 5200 but I'm going to use 4200. Thanks again!

I have to remove my outboard (90hp Merc) to replace my steering cable. Do I have to put anything like silicone or something like that in the 4 bolt holes when I put the motor back on the boat? Oh yea, it's an aluminum boat. Thanks!!

I run the J9s & 11s too but remember they will run deeper then the F9s & 11s.

My buddy caught a couple Browns by Selkirk about 2 weeks ago from the shore.

Thanks!!!

Nice job! What was the water temp?