Jump to content

Rtrucking40

Members
 View Profile  See their activity

  • Posts

    160

  • Joined

  • Last visited

 Content Type 

Everything posted by Rtrucking40

  1. Rtrucking40
    What size dipsey mag or #1 where u running the ring?
  2. Rtrucking40
    Hey did you get then fixed yet? I have the same problem all the time the clutch pads breaking. Really simple back the handle off and remove , theres a thrist washer and spring in there so pay attention to the order they came out, take the 4 screws off the back and push the shaft through that the handle threads onyou will see a fiber pad inbetween 2 washers remove and replace. Sometimes the washers get bent up to but all the parts are really cheap and available on fish 307 just make sure to buy lots of extra pads also had the threads on the hanle strip on me and cannon sent me a updated one for free but fish 307 also carries it.
  3. Rtrucking40
    Sealine sg57 for downrigger Was looking to pickup some reels for downrigger use and i can pickup 2 sealine 57 line counters for around 130 dollars. They will hold 330 yards of 30lb mono which from what i gather is the prefred amount of line on a rigger? They also have a 6.1:1 gear ratio. Is the gear ratio okay for use with downrigger rods? How are the sealines as far as quality. These are new out of box.
  4. Rtrucking40
    DUHh!! Thanks pap i needed to wake up i have offshore snap weights and i completly forgot the .5 will run that shallow!
  5. Rtrucking40
    Spoon depth with split shot in front?? What kinda depth can I expect a stinger spoon and or a scorpion spoon to run at off a planer board Figured at 10lb mono around 40-50 foot behind a board trolling 2-2.5 mph with a split shot 7 foot in front. I got the biggest split shots i found at gander about the size of a pea . Thanks for the help.
  6. Rtrucking40
    I am with hardknox tho I gave up doing it full time I still work on my own stuff and I cracked block would very rarely cause a no start. I just recently worked on a bf8a Honda 4 stroked guy rebuilt carbs all new coils wires etc. it was not pulling fuel and when I checked the compression 1 cyl had 0. Pulled it apart and found a stuck valve. Bent from smacking the piston. New valve guides and springs and it runs like a champ now. Start with spark if you are getting spark verify you are getting fuel. If it will fire on starting fluid your problem is on the fuel side. Check your compression. And are you leaking oil or water from the crack in the block?
  7. Rtrucking40
    Do the 2-7 foot ones dive to deep to be run off a dipsey diver?
  8. Rtrucking40
    What are you guys running these behind any type of flasher or dodger.
  9. Rtrucking40
    So what is the optimum amount of line (feet) to have on a reel to be used on a downrigger
  10. Rtrucking40
    Hey not tryin to hijack this thread but i have almost the same question. Will diawa accudepth 47s work for downriggers? From what i gather its either 25 or 30lb mono will these hold enough line to get the job done? Thanks
×
×
  • Create New...