Ready or Knot

Also has new water pump and drive coupling. Make me an offer. I want it gone. Need the space

Need 3000. Have way more then that in it. Bought a new one from mercruiser is reason its for sale

I have brand new jasper reman sitting on skid. Will ne assembled soon. Starter and alternator just gone through. New fuel pump and carburetor. This is a 205 hp lx motor complete with newer manifolds

I use that exact set up. Works great for me. Braid backing makes them easy to trip due to lack of stretch. I run 50 lb power pro

Is there a way to get the lat/lon lines up on the chart page? Do you have to have a map chip to get this ? New to the helix unit and would like to have these reference lines like my lowrance unit. Thx .

What unit is this for ? May have one

Fished 26th 27th. Bite was good early but shutdown by noon. 180 to 300 fow. 20 to 50 down. All spoons

I too would be more then willing to donate a day to these men. Capt. Marshall Stearns

I know this isnt the right section but got no response from boat page. Does anybody have any feedback on units like the sitex 760 or furuno1623 . Want to have stand alone unit without breaking the bank. Thx guys !

Does anybody have any experience with these lower priced units like the Si-Tex 760 or Furuno 1715 ? Want to have radar without having a mortgage .

Black or dark colored plugs is a sign of a rich fuel condition generally a carburetor issue. Check to be sure that choke is opening all the way. Check pcv valves , vacuum pull off etc. If it is an engine issue the plugs will generally be oilly on the effected cylinders

Can't beat the Barcelona area that time of year. Have had many days of double digit hookups. Try the ledge off the back off Brockton shoals

Just to give you a bit of insight on this. The only difference in marine plywood is that is void free and sometimes has a few more plies increasing its strength. Sheeting grade can be used but be picky when buying it. Glue generously and clamp or weight to laminate the sheets together. Cut all profiles as needed . job is not super tough but takes time. Put at least 2 coats of epoxy over it to seal up. Caulk all drill holes well. We have done a couple of these on I/Os. Your outboard will be easier. Best of luck to you