Jump to content

Recommended Posts

Grumman CC, 16.5’ Center Console, with Mercury 60HP, 15 HP Johnson Kicker, and Venture Trailer. This is a high-sided V-hull, with a full splash-well, capable of handling 2-3 footers on Oneida and Ontario. This is a great Walleye boat on Oneida and is set-up for trout and salmon trolling on the Finger lakes and Lake Ontario. see spec’s below: Boat: Grumman CC, 1988, Aluminum, Restored 2019. New Transom, Floor, Flotation, and Steering Cable. Floor covered with marine grade vinyl & carpeting from Cabela’s. All rivets were coated with Gluvit epoxy sealer. New Bilge and Aerator pumps. Bow seat, driver seat with live-well. Additional location for the bow seat. Mercury 60HP, 1993, long shaft, 2-stroke: New water-pump kit 2016 New Stator, CDI electronics, and Starter Solenoid 2015, by Gagnons Marina. Johnson 15HP, 1996, long shaft, 2-stroke, tiller, with steering bracket to 60hp. New water-pump kit 2016 Trailer: Venture 2004, galvanized, with Trailer Swivel Jack and Spare. New Axel / Bearings / Hubs / Tires / Bearing Buddies, 2018 Accessories included: Lowrance Hook 7, Fish finder / GPS with Lake Insight charting, 2017 Fish Hawk X4, trolling data electronics, 2016 2-Cannon Downriggers, Mag10, electric, 48” boom, swivel bases. These are old but still work fine. (one may need a new up/down switch, as you need to hold it for UP.) 2- (8-10?)# rigger cannon-ball weights and salmon releases. Willey Dual Planer Board Mast and 2 Planer boards (homemade) 2-Dipsey-Rod holders, plus 3 other light holders, multiple stationary rod holders, fore and aft. 1-deep-cycle battery, plus Starter. Motor support bracket, and kicker steering bracket. Minn Kota Bow mounted trolling motor (12v), old, works, but ready to be replaced. Fire Extinguisher, Swim ladder. Asking $5,500 or BO. MSTA Contact: Tom – 315-280-6053 (call or text) Boat is located near Syracuse, NY

View the full article

Link to post
Share on other sites
This topic is now closed to further replies.
  • Create New...