Jump to content
Search In
  • More options...
Find results that contain...
Find results in...

salmonaddict

Members
  • Content Count

    75
  • Joined

  • Last visited

Everything posted by salmonaddict

  1. Is this still available Sent from my iPhone using Lake Ontario United
  2. I will never own a 4 stroke as long as my e tech will run Sent from my iPhone using Lake Ontario United
  3. Mexico point boat launch has a pump out station easily accessible from the water Sent from my iPhone using Lake Ontario United
  4. Pull cable out the crimp or set screw that connects cable depending on model is dirty or corroded Sent from my iPhone using Lake Ontario United
  5. Drinking to much koolaid Sent from my iPhone using Lake Ontario United
  6. Twilli tips will cause fraying and breaks in braid Sent from my iPhone using Lake Ontario United
  7. Run a drift bag off each side in rough water will make boat more stable and allow you to run motor at a higher rpm so you also have more control Sent from my iPhone using Lake Ontario United
  8. This man told me Mexico was his jurisdiction and it was going to be open Sent from my iPhone using Lake Ontario United
  9. I just called encon officer Derrett from parish New York. He said launches that didn’t offer any services that were maned by machines like Mexico point and pine grove will remain open Sent from my iPhone using Lake Ontario United
  10. Salmon country marina on little salmon river Sent from my iPhone using Lake Ontario United
  11. For me it depends on my target I might run wire on inside dipsey and mono on the outside one if steelhead are present. Or if I am just targeting kings it might be steel on both Sent from my iPhone using Lake Ontario United
  12. We run meat flasher fly and spoons all at same time and faster than most think possible just have to tune head to spin properly at the speed you are running Sent from my iPhone using Lake Ontario United
  13. I have put a trollmaster on my last 2 boats and would not fish without it. Have had no problems other than some interference with fishhawk on first install had to reroute wires and fixed it Sent from my iPhone using Lake Ontario United
  14. I wires for new motor are coming in contact with wire for temp unit or even close may have to shield them. Sometimes it is as easy as wrapping them in aluminum foil or routing them differently if you have 2 batteries make sure power for temp unit is coming from opposite battery as the kicker Sent from my iPhone using Lake Ontario United
  15. Best year in a long time for kings Sent from my iPhone using Lake Ontario United
  16. I have cut back this year to 20 feet for leader and haven’t seen any drop in catch rate Sent from my iPhone using Lake Ontario United
  17. I set my probe as my deep rigger at 42 degrees and work up from there. Sent from my iPhone using Lake Ontario United
  18. That would not be 19 strand Sent from my iPhone using Lake Ontario United
  19. That would run just below where the 300 copper runs 19 strand don’t sink anywhere near the same as copper on it’s own it requires waight or a dipsey to pull it down Sent from my iPhone using Lake Ontario United
  20. You can run 4 or 6 dipsey without using boards by putting on different settings I see no reason for this Sent from my iPhone using Lake Ontario United
  21. Start out deploying copper first let it out slow and you will have no problems. After you get the hang of it you can deploy it out the back of boat and move it over the top of your dipsey. I use tx44 boards and put copper back wherever it was in my spread without pulling rods all the time Sent from my iPhone using Lake Ontario United
  22. They added to the floating dock at Mexico point but now you have to put your whole truck in the water to retreave your boat not sure that is good either. Water not deep enough until you get back to ramp Sent from my iPhone using Lake Ontario United
  23. More mature fish than I have gotten at this time of year in the past Sent from my iPhone using Lake Ontario United
×
×
  • Create New...