Sold / Closed DROP IN ready !275 HP / 350 Chev

[aeroman]

COME AND RUN IT IN TEST STAND AS LONG AS YOU WANT --BRING A SCREW IN COMPRESSION TESTER!!!
STANDARD EQUIPMENT INCLUDES:
· 5.7L engine (standard rotation)
· MerCruiser exhaust manifolds & risers (these are like new--can remove one to see inside!)
· Power steering pump with cooler
· Weber 750cfm, 4-barrel marine carburetor
· Carter 0-3000 Mechanical fuel pump
PERTRONICS Ignition System, spark plugs and wires

· 14" sterndrive flywheel, MerCruiser coupler, and bell housing

· High torque bottom mount starter (U.S.C.G. approved)
· MerCruiser engine wire harness (10-pin plug)
· Thermostat housing with thermostat
Dual temp sensors
oil sending unit
· Cast nodular iron heads
· Engine Coupler
· Bell Housing
· High-flow oil pump
· High-flow flame arrestor with cover
· Dipstick & dipstick tube
· Corrosion resistant black urethane paint
· Motor mounts
Lifting rings installed

ENGINE SPECIFICATIONS:
Compresion test (screw in tester) 145 PSI.
· Horsepower: 275hp
· WOT Operating Range: 4400-4800 rpm
· Engine Configuration: GM Small Block V-8
· Displacement: 357 ci / 5.7L
· Compression Ratio: 9.4:1
· Idle Speed: 650 rpm

General engine appearance and condition indicate a recent rebuild to Mercruiser specs- METAL Mercruiser plate attached to housing with rebuild S/N number : F073267

Asking 3200$- Check out Michigan Marines website -they want 6400 plus shipping and crating(300) for a drop in!!

"Y" DOWN PIPES(WISHBONE) IN PHOTOS AR Part of test stand and are NOT INCLUDED.


Greg 613 825-6082- location west Ottawa ,Canada -email - [email protected]

Edited September 7, 2013 by aeroman