sub troll still not working

[smaltcody]

So now the tempature reads for about a second after coming out of the water and nothing while it is in the water no speed nothing I have walker down diggers any help is very appreciated

[ Post made via Android ]

[spoonfed-1]

I've had to replace the long cable that runs from the readout to the antenna twice in about 8 years or so.

The internal connection in the plug broke from plugging and unplugging every trip as I keep my electronics in the cabin when the boat is not in use.

Might want to check that.

Glen

[Don Supon]

Once had a soldered wire to the battery clip in the probe come apart.

[LongLine]

As long as you have the dot on the display, the power head should be ok. Power does have a direct path to the battery right? and not thru any boat electronics terminals? Like above, I'm guessing a connection.

Paddle wheel rotates freely? Coated cable?

When you unscrew the cap, you don't have any water coming out do you? New battery?

If you've gone thru everything in the manual, you might want to call moor electronics. www.moorelectronics.com

Tom B.

(LongLine)

[alyakhim]

sounds like you have a small nick in the coated rigger cable in the range above the sub troll because of the intermittent operation right before pulling it out of the water. inspect carefully as a fray in the wire will cause a short

[ Post made via Mobile Device ]

[smaltcody]

Thanks for the help I fixed my problem it was the cable from the antenna to the head I used a ohm meter tested and it was bad replaced it now works good

[ Post made via Android ]

[spoonfed-1]

Thanks for the help I fixed my problem it was the cable from the antenna to the head I used a ohm meter tested and it was bad replaced it now works good

[ Post made via Android ]