jerryriggin

To each there own. I will take my chances on the magnum metalz bouncing the probe of the tip with there clutch system versus a cannon that the auto stop could malfunction on. I can guarantee more probes have been lost to the bottom of the lake by other manufactures with auto stop then by magnum metalz.

Crowley marine.

I guess im different when we are trout fishing we fight them with the rod tip pointed towards the water to ensure there mouth doesnt come out of the water.

I would use the magdas on riggers and convectors for divers. Not optimum size for each but id rather have the better reel on the divers.

Dont have many problems with rigger fish going under the divers. Once in awhile on a turn but going straight hardly ever.

I do run a copper over the high and low but prefer to not go over a 300 copper to keep down the number of tangles.

I run mine on 1.5 and 3 for the low and high. I figure low runs 2 to 1 for depth and high runs 3 to 1. So a normal set to fish 90 down would be high back 270 to 300 and low back 180. I use all 124mm dreamweaver divers but i change the weight and bottom cover out on the high diver to one from a 107 diver to get seperation of the divers. I have ran both 124s with the big weight for high and lows but felt my bites went down.

I trim the curly ends back until i get down to around 700 feet then replace the wire so it takes a few years last time i replaced it was over 10 years old.

Pm sent

this do not do. Get yourself a 1000 ft spool of .015 wire and wind it on the reel. You do not want splices all over in your dipseys wire.Sent from my SAMSUNG-SM-N910A using Lake Ontario United mobile app

Big Weenie shut the website down for the summer it will reopen later in the year. Sent from my SAMSUNG-SM-N910A using Lake Ontario United mobile app

Simplest way to a full reel. Start with 2 of the same reels put wire first then mono till full then crank mono and wire on to the empty reel. Take a note of where the mono ends and wire begins on the second reel. Also doing it this way u put the wire on under drag so it is nice and tight and ready to fish when u get to the lake. Sent from my SAMSUNG-SM-N910A using Lake Ontario United mobile app

Penn 309 will hold more then enough wire and backer. 1000 ft of .015 wire fills a diawa 47lc just right and a 309 has much more capacity then the 47lc. Regular dipseys rod will work fine just change the tip to a twilli tip. Sent from my SAMSUNG-SM-N910A using Lake Ontario United mobile app

Protroll and michigan stinger blades are one in the same. It is just stinger has hundreds of different colors. There are no echips on the LJ or dreamweaver paddles but they both poduce fish. Sent from my SAMSUNG-SM-N910A using Lake Ontario United mobile app

Think about it this way. The fish is attacking an 8 inch piece of plastic with a fly attached to it 22 inches behind with 40 or 50 lb. There is no need for a lighter leader to the flasher Sent from my SAMSUNG-SM-N910A using Lake Ontario United mobile app

Tie to the mainline. Sent from my SAMSUNG-SM-N910A using Lake Ontario United mobile app

Wrap a wet towel on the antenna and see if it works deeper Sent from my SAMSUNG-SM-N910A using Lake Ontario United mobile app

I run 2 124mm walker deeper divers per side. The low is set on 1.5 and the hi is set on 3 but I swap out the weight of the high with a 107 mm diver. Sent from my SAMSUNG-SM-N910A using Lake Ontario United mobile app