Jump to content

Where to mount Dippsy rod holders; forward or aft?


Recommended Posts

I am looking for advice on whether to mount my new dippsy rod holders, which are Berts Ratchet style, on the right and left sides near the transom or up closer to the middle of the boat (helm position).

Due to the location of rod storage lockers these postions are my only choices.

Which position would be better for turning, etc. and cause less potential for line fouling with riggers and in-line planers?

Thanks,

Trout Bum

Link to post
Share on other sites

mine are forward closer to center...if yer turning so sharp that ya lay the lines across the riggers yer probly turning too sharp anyways :@ sometimes with my boat 22ft alum. and a strong side wind ill speed up a tad or if its real bad ya might wanna consider popin the one thats gonna be (could be) draggin across the wires... i usually only "force the turn" when i need to get back to a "hot " spot on a slow day or derby.

Link to post
Share on other sites

Dipsey rods go forward of all my riggers (closer to the helm) . I run 4 riggers, one on each corner and one on each side out 90 degrees. Like Ray said watch your turns and hit the throttle a little to control your rods.

2012_05_13_07_02_06_489.jpg

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...