-
Posts
6,923 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Store
Everything posted by Gill-T
-
-
-
Doesn’t Suzuki make the Mercury engines? If so, I would think any Merc dealer could help.
-
Thanks. With the 10’s of millions of walleye in the system, nobody should be shy about posting a report. Lots of fish for everyone when they get here. I don’t think they have reached the Catt in any numbers as we noticed there were only 4 boat trailers in the Hanover lot when we stopped in to the fish cleaning station.
-
-
Interesting. I imagine the max scent stuff might be even better. Keep the reports going. Thanks for posting!
-
-
A word of caution if you are clamping on mono. The little pointy triangular rumble strip that helps secure the release pressing against the line will crimp and weaken your mono. I ground those sharp rumble strips down with a dremmel tool and increased the release hold by putting a small piece of 3M double sided tape down so the release arm pinches the line down into the tape. No slippage.
-
-
Yep. 1.5 setting on inside. I run a four pack of slides. Mags on inside. Standards on outside. To help avoid divers getting together, I run standards on 40 lb wire and mags on 30 lb wire (gains separation). I also set them exactly the same by laying them out on the lawn to confirm all my leaders are the same length, the mono leader I clamp onto is the same, the small piece of braid between the mono and wire is the same. Each side is run the same distance back so they fall together, and the opposing side may vary but not much. For example a spread of four divers might have two port side divers (a standard and a mag) both out 250’ out and two starboard divers (a standard and a mag) out 275’. In conditions of extreme changing down currents, like near the red can- Niagara Bar, I will pull the two inside divers before I turn 180 to go back over my line, otherwise, I can leave all 4 divers in the water and turn completely around without tangles. Slide divers are great in that they don’t spin on themselves so you can bass flip a standard outside the inside mag when resetting.
-
-
-
-
-
Sodus 6/19 a.m.
Gill-T replied to Hillside's topic in New York Fishing Reports - Lake Ontario (South Shore)
-
-
Sandy 6/18 Fathers Day Evening
Gill-T replied to fisherman21's topic in New York Fishing Reports - Lake Ontario (South Shore)
-
Net Pen in 130 ft of water N of Oswego, trollers beware
Gill-T replied to schreckstoff's topic in Open Lake Discussion
Some discussion on Cisco and other fisheries -
-
https://seagull.glos.org/map?coords=-78.9898305%2C43.2738554%2C6.8&tags=platforms%3Abuoy%2Cweather%3Awater_current%2Cwater%3A%2Cfavorite%3A
-
Olcott june 10
Gill-T replied to Triumphchaos83's topic in New York Fishing Reports - Lake Ontario (South Shore)
My brother was out today. The water in closer didn’t look promising so he ended up offshore with some steel and a king to show for it. 48 degrees down 60’ with lots of currents moving fish around. Typical June fishing -
The same knot you use for a wire dipsy swivel.
-
Or save your money and tie the wire line knot to your terminal swivel