Jump to content

All Activity

This stream auto-updates

  1. Past hour
  2. Works as it should, comes with maga transducer, gimbal mount, helix network cable adapter and power cord Located in Rochester Will ship if needed $1250
  3. Works as it should, comes with XM 9 20 MSI T transducer, gimbal mount, helix network cable adapter and power cord Located in Rochester Will ship if needed $1250
  4. Today
  5. water level is a little lower than average but not bad. havent heard any thing on pike but good reports on walleye.
  6. Bear's Bait Shop will be holding a Perch Derby on Cayuga Lake Saturday/Sunday June 8th and 9th 2024. Attached is the entry form for the tournament. You can also sign up at Bear's Baits, located at Myers Park in Lansing, New York.
  7. Did a little evening into night troll. Haven’t been walleye fishing at night for over a decade. More exploration of some points paid dividends again. Got some bigs. Lost two bigs due to netting FuBAR. Some giant sheep made it interesting. Yellow and white perch, and some smallmouth. Livingston Lures were proving again that they are worth the $14 they cost.
  8. There are 2 main general currents in the lake. (double gyre) The 1st starts at Niagara and follows the south shore all the way up to Henderson. Some of it flows out the St Lawrence while the rest curves back and heads south hitting the south shore somewhere between Oswego/Sodus. It then circles back up the coast. The 2nd starts at Niagara and flows along the north shore and goes up past Kingston where it meets the south shore current. It is then deflected back west farther from shore and hooks southward at the Scotch Bonnet ridge towards Sandy/Braddocks and meets up with the south shore current. A strong easterly blow will slow the shore currents slightly and may shift the areas of south shore contact somewhat, however the lake recovers a couple days after the east wind dies out. If I remember my hydrology correctly, pure wind action on water affects the water 5 to 6 times the wave height. Currents on the lake are a "bear" to figure out on any given day which is why a down speed probe is a necessity.
  9. Concentrate on the riggers first, then move on to the other "stuff." (Dipseys, cores, etc) - 1 lure in temp, 1 lure above and 1 below. - spooks (Black/silver with a splash of red) - Troll North & South watching temps. Fish stable water. Temp probe on the deeper rigger. - Occasionally take down speed up to 3 or a little higher then slow back down. Occasionally put it in neutral & let spoons flutter downward. - Run a MUP rig. Two identical lures on a rigger about 10-12 ft apart vertically. Run lower one about 15 ft behind the upper. Can also try flasher/fly high with spoon low (same colors) but don't put it in neutral. - If you spot a scum line, troll to outside of it. If you spot bait fish pod, troll to outside of it. (Go at least 30FOW deeper then back in) If you see birds, troll to the outside of them. - Keep your eyes on the water. If you see minnows or fish swirling, then get a plug on the surface. (maybe only 4-5 ft down) Good luck out there.
  10. The convectors are sold. I'd take 185 for each tekota plus 10 to ship them.
  11. Yesterday
  12. Thanks Mike best to you as well. Pete mentioned the ones you've been having success with. I'm sure you will do well out there bud.
  13. Won’t be doing the tournament this weekend as I have grandpa duty which means any time on the boat will be for pleasure rides. Good luck to all. I haven’t been chasing the lakers but the silvers have been pretty good so far(except for the lampreys). Hope the weather holds 🤞
  14. Love those Elmer Hinckley spoons Les! I got some more this week too! Good luck out there everyone!
  15. Good luck Les! Anyone out there that was lucky enough to get #1 ticket entry should earn the grand prize!!!🏆
  16. Best of luck to all fishing the Seneca Derby tomorrow. I received my new Elmer Hinckley spoons in today's mail and they are incredible. The finish blows away my former favorite spoons. I'm hoping for a good result this weekend. Hope the weather holds and the wind is right.
  17. PM “Chowder” on this site if you want a guided trip for cats on the Cattaurgus. The run has started
  18. The size of fish and quantities seem to be trending back to the haydays. The K/D tournament gives a good history of sizes. Obviously Lake Ontario is an amazing fishery, was just referencing the discussion of salmon size.
  19. For sale brand new in original factory box, never opened. On hands, very hard to get due to parts shortage, well below OEM price (close to 3G). 9148T85, V6 / 6-Cylinder 150, 175, 200hp 2.5 Liter XLong, 25″ Shaft Standard Rotation, Right Hand* OEM #1647-9148T85 New OEM Lower made by Mercury Marine. Genuine Factory, OEM Parts OEM #1647-9148T85 This Mercury 9148T85 GC 2.5L XL 1.87 fits many Mercury/Mariner engines. Please check for fitment prior to buying. Item also can be delivered free along NYS I81 corridor after payment.
  1. Load more activity
×
×
  • Create New...