Jump to content

All Activity

This stream auto-updates

  1. Past hour
  2. jollyroger
    i have been using ugly stiks for 40 years, from spinning rods to 8'3" and 9'0" for rigger rods and board rods and 10' for divers and copper and weighted steel. (big water series) now i use the newer 9' ml for the riggers (a little more backbone than the light action, but not too much) the only difference i have noticed between the old and new models is the guides. i have never had a failure with any of them. hope this helps. tight lines for your choice on a new one.
  3. red lobster

    Rock bass

    red lobster posted a topic in Panfish

    Fished Oak Orchard Creek out of Captains Cove at the bridges Wednesday. Headed up creek south/southwest toward Waterport dam. Caught many nice rockies, perch and bluegills. Fishing around downed trees with purple bent wire fuzzy jigs, 11 year old Grandsons homemade flies and trout magnets, all tipped with a piece of worm. For real fun try a cane pole to reach into the tangles where you can't cast. For the gar fisherman there are packs of them cruising all the shorelines. Must be spawning. Never saw so many gar. Some I'd estimate pushing 40 inches.
  4. Shattered
    Excellent!
  5. sherman brown
    I have always used 8' or longer ML downrigger rods and never had one that was too stiff for my riggers. a rod you should really check out is the Daiwa GX2 ugly stick med action on these rods are limber enough for riggers. but a light action might be a better option for you but not needed. I just took a quick look on eBay and 1 listing is for 3 light action 9' rods for 95.00 and free shipping.
  6. Baha30
    Do you still have that broken AP14 helm unit by chance?? Need some parts out of one and have been searching the internet for parts. Would be willing to buy it from you..
  7. sherman brown
    you will be so much better off with lithium. they run much longer and can be discharged much lower than lead/acid batteries. they do cost more but shop around at places like Amazon before you buy.
  8. sherman brown
    have you removed the lower screw and checked to see if any water or milky grease came out? if just lower unit grease comes out close it up and put more grease in to make sure if it's low. I have had outdrives have what looks like the same thing but it turned out to be nothing but exhaust scum and water.
  9. Today
  10. gunnysargent12
    All sold. Thanks LOU and all who purchased. FISH ON!
  11. sherman brown
    I hate to come off as an AH but on the 1st picture, it plainly reads four stroke.
  12. Steve.e
    Is that a 2 or 4 stroke?
  13. MBarbieri
    Yes! Just found them looks awesome a little pricey but should do the trick!
  14. thumbburn
    Thanks hank…. Hoping you would chime in….. I actually heard something funky when I put it in gear that day I last used it…. Funny how more details come out of my brain when I get a cpl answers….
  15. Shattered
    These guys should… https://www.itroll.us
  16. L&M
    As Chinook said , it's probably the shift shaft seal or upper driveshaft seal but a pressure test will tell for sure. It could be the lower driveshaft seal under the pump but that would normally show itself in the water intake or out the prop area with the drive down. If the upper input yoke seal was leaking you would only see it in the bellows as said above.
  17. Scalloper 1
    No, saltwater to freshwater to spawn.
  18. Bad Habit
    I Came across this in an old Garmin monochrome GPS I had in the basement. I realize it's almost 30 years old but if someone can use it it's yours. I Just thought I would throw it out there before I tossed it. I'm located in Penfield NY. Just drop me a PM.
  19. MBarbieri
    Just put a new 20hp yamaha on my 1991 Tracker DeepV does anyone have a throttle control like the ConTrollking or TrollMaster that works with EFI motors?
  20. troubles
    more available
  21. Silver Fox
    Last year it was in June and the gun club was pretty full. This years attendance was terrible. Probably because I knew guys that were gone for the derby. Maybe that was part of the reason.
  22. troubles
    $20 includes shipping all new material PayPal friends and family please is [email protected] Venmo is @Gregory-Dale-17 send pm
  23. chinook35
    If the drive shaft seal is leaking , the gear oil will be contained in the drive shaft bellows and you may see it in the bilge if it gets past the gimbal bearing. No way will you see it as an external drip unless the bellows is torn or punctured.
  24. finsntins
    impressive laker,congrats!!!
  25. tim
    Should I get a look lead acid battery or should I go the extra money for lithium? Not something I’m going to use every day once in a while never had a trolling motor so I don’t know.
  26. troubles
    $20 includes shipping all new material PayPal friends and family please is [email protected] Venmo is @Gregory-Dale-17 send pm
  27. mattym22
    DOUGLAS FISHING ROD ITEM# 30010 SERIES# XMATRIX MODEL# DXS 7103MF 7' 10" BRAND NEW 275.00 LOCATED 14623 AREA THANKS
  1. Load more activity
×
×
  • Create New...